|
|
|
|
|
|
|
|
|
|
|
|
| STEELER® INC. Shaft Walls |
|
| C-H Studs & J-Track for Shaft Wall
Construction |
|
| 1-800-275-2279 |
|
|
|
| Steeler Inc.'s Engineered C-H Stud and J-Track are an economical
solution to Shaft Wall Systems.
Steeler C-H shaped studs are shaped by cold-formed shaping of the
steel, which increases the strength of the C-H stud. Other competing Shaft Wall Systems use
knock out tabs to hold the shaft liner in place, however these knock-out tabs
reduce the strength of those Shaft Wall studs and reduce the limiting wall
heights of such walls. Steeler C-H are safer and easier to work with because
the edges (except for one lip return) are hemmed and there are no sharp knock
out tabs to worry about. |
|
| Steeler
J-Track is manufactured from steel meeting the requirements of ASTM C653-02a
or equal, Grade 33 (fy=33KSI). |
|
| J-Track is used for top, bottom, and end of wall track in
construction of Shaft Wall Systems. |
|
|
| Steeler J-Track is available with webs of 2 1/2", 4",
and 6". The long flange is 2 1/4" and short flange (stiffener) is
available with 1" and 2" flanges. |
|
| 6" C-H Stud
Diagram |
J - Track Diagram |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| J-Track
Part #: |
Web (A): |
|
Flange (B): |
Stiffener flange (C): |
Thickness: |
|
| 0250J100 |
|
2 1/2" |
|
2 1/4" |
|
1" |
|
18, 27, 30, 33 mils |
|
| 0250J200 |
|
2 1/2" |
|
2 1/4" |
|
2" |
|
18, 27, 30, 33 mils |
|
| 0400J100 |
|
4" |
|
2 1/4" |
|
1" |
|
18, 27, 30, 33 mils |
|
| 0400J200 |
|
4" |
|
2 1/4" |
|
2" |
|
18, 27, 30, 33 mils |
|
| 0600J100 |
|
6" |
|
2 1/4" |
|
1" |
|
18, 27, 30, 33 mils |
|
| 0600J200 |
|
6" |
|
2 1/4" |
|
2" |
|
18, 27, 30, 33 mils |
|
| *Part # Notes: Desired thickness of
J-Track is indicated by appending mil thickness to part # listed above. |
|
|
|
|
|
|
|
| Steeler
and Steeler, Inc. are registered trademarks of Steeler, Inc. Copyright 2003
Steeler, Inc. All Rights Reserved. |
|
June 6, 2003 |
|
PAGE 1 |
|
|
|
|
|
|
|
|
|
|
|
